MACROMEDIA COLDFUSION MX 7.0.2-USING COLDFUSION MX WITH FLEX 2 Betriebsanweisung PDF herunterladen (Seite 152)

152 Use Behaviors

Create a behavior

You decide to create a behavior so that a button glows when a user clicks it. You want the glow

to be green, last one and a half seconds, and leave the button a pale green to indicate it was

clicked.

1. With your Lessons project selected in the Navigator view, select File > New > MXML

Application and create an application file called Behaviors.mxml.

2. Designate the Behaviors.mxml file as the default file to be compiled by right-clicking

(Control-click on Macintosh) the file in the Navigator view and selecting Set As Default

Application from the context menu.

3. In the MXML editor’s Source mode, define a Glow effect by entering the following tag

after the opening

<mx:Application> tag:

<mx:Glow id="buttonGlow" color="0x99FF66" alphaFrom="1.0" alphaTo="0.3"

duration="1500"/>

The Glow effect starts fully opaque and gradually becomes more transparent, but not fully

transparent. A pale glow persists after the effect has played to indicate that the button was

clicked.

4. In Design mode, drag a Panel container into the layout from the Layout category of the

Components view, and then set the following Panel properties in the Properties view:

■ Width: 200

■ Height: 300

■ X: 10

■ Y: 10

5. Drag a Button control into the Panel from the Controls category of the Components view,

and then set the following Button properties in the Properties view:

■ ID: myButton

■ Label: View

■ X: 40

■ Y: 60

NOTE

For the purpose of these lessons, several application files are used in a single Flex

Builder project. However, it’s good practice to have only one MXML application file

per project.

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 255 256

Keine Kommentare

MACROMEDIA COLDFUSION MX 7.0.2-USING COLDFUSION MX WITH FLEX 2 Betriebsanweisung Seite 152